How-To: Calibrate a 3730-3 HART Positioner (120 cm², Fail Open)
Step by Step Instructions:
To prepare the positioner for fail-open operation, slide the "AIR TO" switch to the "CLOSE" position.
For small actuators such as the 120 cm², it's advisable to restrict the output air volume to approximately 50 %.
Begin the calibration process by entering configuration mode. Using the rotary push button, turn it until parameter 3 is shown, and push the button. Turn again until the display shows "Yes", and push to accept the change.
Parameter 4 indicates the pin position and is set to 35.
Parameter 5 sets our travel, and is kept at 15 mm.
Parameter 6 is changed to nominal to use our 15 mm stroke rather than the valve maximum.
The final parameter to set is 7, this is our operating direction and is set to increasing-decreasing for standard fail-open operation.
Now, go back to parameter zero and press the recessed initialization button to begin the auto calibration process.
This process can take a few minutes while the positioner adapts itself to this specific valve and it's operating characteristics. It is important not to disturb or interrupt this process until it's finished.
Once the calibration is completed, the display will briefly show "Tune", and then revert to the position specified by the control signal.
To confirm correct operation, cycle through various set-points and ensure the valve responds accurately.
The positioner is now calibrated and ready for operation.
We use cookies and assets
We use cookies and similar technologies (assets) to ensure that you get the most out of our website based on the data we collect. If you accept the predefined cookie settings, by default we only use the essential cookies and assets as well as the anonymized analytics by Matamo.
We use these cookies and assets to offer you various services, such as the NE53 newsletter, virtual tours, videos und online maps. For this purpose, we and the relevant service providers use the information obtained by the cookies and assets to analyze and save this information. Such information may include details of your end device and certain personal data (e.g. IP address, browser history, geolocation data or unique identifiers).
Processing of personal data in third countries (outside the EU) by YouTube and Google
If you select "Accept all" or individual services, you consent to the processing of your personal data in the US according to Article 49(1) lit. a) GDPR. According to the Court of Justice of the European Union, the US has a lower level of data protection than in the EU. The reason behind this judgment is that personal data could be processed by US authorities for control or monitoring purposes without the possibility to appeal to the same extent provided by EU standards.
Analytics
For user behavior tracking, we use the Matomo tool with IP anonymization (i.e. the last three digits of your IP address are masked and not not passed on to third parties) by default to comply with privacy laws. Our "legitimate interest" governed by Article 6(1) lit. f) GDPR is the legal grounds for processing the data. You can object here to this processing.
For more information on which data are collected and how they are used, please read our privacy and cookie guidelines: